Plaid® Hot Glue Gun Helpers
FolkArt ® Acrylic Paints Warm White
Light colored wood frame
Bowl of water
Foam-core board
Craft knife
Hot glue
Decorator fabric
Batting
Twill tape
Buttons
Duct tape
Loose bristle paintbrush
Paper towels
Foam plates
Please read and follow all manufacturers’ instructions for all tools and materials used. Provide adult supervision if children participate in this
project.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom
from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained,
Plaid Enterprises, Inc.disclaims any liability for untoward results.
Intermediate Skill Level | 2 Hour Crafting Time
1. Thin the Warm White paint with a little water. Dip the paintbrush into the paint and tap off the
excess. Working quickly, paint the frame. Make sure you leave areas where the paint is thick
and thin to achieve the antique look.
2. Trim the foam-core board to fit inside the frame. Trim batting to fit the foam-core board. Glue
batting to the foam-core board.
3. Lay the fabric (print side down) flat on your work surface. Trim the fabric so that it is larger than
the foam-core board. 2” extra all the way around should be enough.
4. On the backside, add a drop of hot glue to each corner and pull back the corner of the fabric.
Press into the hot glue. (Wear Hot Glue Gun Helper finger caps so you don’t burn your fingers)
Add a strip of hot glue down the side edges and fold back the fabric into the hot glue. Make sure
your fabric is taut.
5. Measure and cut the twill tape into 6 pieces. You will need to add an extra few inches for
wrapping around to the back. Two pieces will be long and four will be shorter. The longer pieces
will go across the entire board (corner to corner) and the short pieces will wrap around the corner
areas. Using hot glue and using the photo as a guide, hot glue the ends of the ribbons to the
back of the board. Add a drop of hot glue where the ribbons meet to secure it to the base of the
board. Glue a decorative button where the ribbons cross for a little pop.
6. Position the board into the frame. Add hot glue to secure. Use strips of Duct tape to secure the
board to the frame.
PROJECT TIP: Use vintage pins instead of buttons for a little extra bling.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale